Data sheet Fig18 of UCC28070 that it connect an IMO pin directly and do not malfunction?
Is not resistance necessary to separate when IMO pin connect?
This is a case where the two UCC28070s are connected in parallel. The use of a single RIMO resistor to ground provides a common reference for all four phases of the circuit. since they are current sources the currents from the two UCC28070 will automatically add aand don't need any resistors between them.
In reply to John Bottrill:
Dear John Bottrill
Thank you very much for your answer.May I ask one more question?
I use UCC28070 and operate it in Four-Phase period, but switching becomes unstable.
Would you show me a figure of controller part PCB Layout if you are possible?
Is there Four-Phase period such as PCB Layout of slur037.pdf?
I hope your kind answer.
In reply to Bob Lee62837:
I don't have anything like that.
Thank you very much for thinking of answer.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.