LM10011: SET pin max

Bernhard Boehmer

Expert 1050 points

Part Number: LM10011

Hello TI,

Please confirm whether the resistor on SET may be:

a) increased above 301k

b) left off

Will IDAC_OUT in both of these cases remain below 0.1µA?

over 6 years ago

0 David Baba over 6 years ago

TI__Mastermind 26520 points

Hello Bernhard,

Any RSET value equal to or greater than 301k will select IDAC out = 60nA. As good practice, I advice to place a 301kR resistor for Rset to avoid high impedance nodes.

Hope this helps?

David.

Power management

Power management forum

LM10011: SET pin max