TI E2E Community
LED Driver Forum
TPS61042 CTRL enable Ton time
In the datasheet the "ton" spec for minimum CTRL pulse width to enable is 500uS. I've got an application where code was written targeting 500uS but due to tolerances the pulse could be as low as 457uS. The spec test conditions were for -40 to 85C. If actual operating range is 0-40C and voltage is 3V can there be any guarantee that the part will operate correctly or will software need to be re-written?
To answer your question about MIN specified in the datasheet, this is indeed the MIN required over the operating conditions specified, no fudge-factor allowed! While it may be possible that some devices may work outside the specified range, there is no guarantee that all devices will, as process variations cause subltle variations in the operation.
Having said this, I'm looking at the TPS61042 datasheet, ( http://www.ti.com/lit/ds/symlink/tps61042.pdf ) and on page 3, I see CTRL Ton is 50uS, not 500uS. Also, page 10 Fig 16 shows TON Enable MIN of 50uS, so I'm not sure where you got the 500uS figure, and indeed, if the Ton is 457uS, no problem.
Let me know if I have missed something, but the answer to the basic question is > the specification must be adhered to. 3
Thanks for the reply Leonard. The datasheet we were viewing was version SLVS441B. I can see that the spec was updated in version SLVS441C to 50uS so we should be all set.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.