LM3447 non-isolating buck boost design?

Goutham Bondugula

Prodigy 110 points

Other Parts Discussed in Thread: LM3447

I want to design buck boost on lm3447..can anyone help me out to design transformer on epc13?

over 8 years ago

0 JCHK over 8 years ago

TI__Mastermind 43580 points

HI Goutham,

We have a reference design at TI designs :

If the above link does not work, just search for PMP8025.

Here you can download the schematics, BOM, Gerber files, and test reports. So this should be a great starting point for you.

Regards,

0 Goutham Bondugula over 8 years ago

Prodigy 110 points

Thank you John..Is there any tool for lm3447 buck-boost topology?

0 Clinton Jensen over 8 years ago in reply to Goutham Bondugula

TI__Mastermind 25500 points

You can use the spreadsheet that is already on the web. Just make the turns ratio 1:1 and that will give you the calculations for the non-isolated buck-boost.

0 Goutham Bondugula over 8 years ago in reply to Clinton Jensen

Prodigy 110 points

Okay.. I understood
There is no secondary right
Thanks for the info

0 Clinton Jensen over 8 years ago in reply to Goutham Bondugula

TI__Mastermind 25500 points

That is correct. You will just use an inductor with the primary inductance value and no secondary.

0 Goutham Bondugula over 8 years ago in reply to Clinton Jensen

Prodigy 110 points

thanks Clinton

Power management

Power management forum

LM3447 non-isolating buck boost design?