PSpice model at TPS7A4101

masa0301

Intellectual 960 points

Other Parts Discussed in Thread: TPS7A4101

My coustomer want to use PSpice model at TPS7A4101.

But WEB attached spice model not supported coustomer software.

Do you have a other spice model?

Coustomer want to use [Micro cap].

http://www.spectrum-soft.com/manual.shtm

Or would you give me a equivalent circuit?

Best regards,

masa

over 10 years ago

0 Ryan Eslinger over 10 years ago

TI__Guru 55940 points

Hi Masa,

The only model we have available at this time is the PSpice Transient Model on the product's page.

Very Respectfully,

Ryan

0 masa0301 over 10 years ago in reply to Ryan Eslinger

Intellectual 960 points

Hi Ryan

Thank you for your answer.

Best regards,

Masa

0 Rainer Scalick over 9 years ago in reply to masa0301

Prodigy 75 points

Hi Ryan,

I try to put the TPS7A4101 into my Simulation.

I became some node Errors, and I have seen the .lib is not correct. The device has 5 Pins and the Simulation file

has 6 Pins.... When I put the PWPD into my symbol then I became the Error to few Nodes. The first line is not correct. Do you have an different PSpice File, or a different .lib file?

0 Ryan Eslinger over 9 years ago in reply to Rainer Scalick

TI__Guru 55940 points

Hi Rainer,

I will answer on the new thread that you had started with the same question.

Very Respectfully,

Ryan

Power management

Power management forum

PSpice model at TPS7A4101