TI E2E Community
Non-Isolated DC/DC Forum
Should TPS54325 output recover from short automatically? I guess that it should, as it is stated in the datasheet that the over current protection is not latching.
I have the TPS54325 mounted in a board and I observe the following:
1) TPS54325 starts up fine after rasing edge of EN pin, nevertheless when the output is shorted, the output is stuck at 0 V endlessly even though the short is removed (EN pin continues HIGH).
2) In this situation, if EN pin is set consecutively LOW (disabled) and HIGH (enabled), the output goes to the desired value.
What could be happenning? As indicated in the datasheet, output under-voltage protection circuit could be activated, but I do not know wheter it is latching.
We are very happy with this switcher regulator and we are interested in solving this issue.
The under-voltage protection circuit is being activated due to the short and this protection is latching. The link below applies to the TPS54325 too.
DC/DC Power Applications Engineer
Thanks for your prompt response.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.