Welcome to the Non-Isolated DC/DC Section of the TI E2E Support Community. Ask questions, share knowledge, explore ideas, and help solve problems with fellow engineers. To post a question, click on the forum tab then "New Post".
Q: TPS62260 SW switching waveform by 318382
Our customer asks about the SW swtiching voltage looks exceed the ABS MAX voltage -0.3V. The attachment shows the evaluation result of both customer's board and TI EVM. Both of the SW wave form shows that SW voltage is down to -0.7V in larger than 100mA load condition due to turning off high side and low side FET at tthe switching cycle. Does it make a reliability problem on SW node due to functioning by exceeding ABS MAX -0.3V condition.
A: Re: TPS62260 SW switching waveform by 10449
The negative voltage on the SW node is caused by the current flowing from ground into the TPS62260 synchronous rectifier and out of the SW pin to the inductor. The current flows through this path after the power FET turns off. After the power FET turns off and before the synchronous FET turns on, the current flows through the TPS62260 synchronous FET's parasitic diode. This normal and expected and will not damage the IC. This negative voltage spike is present on all synchronous buck converters from TI and all other companies and is not a problem.
Note the voltage spike in the light load condition. This is caused by the inductor current flowing into the SW node and through the power FET's diode to Vin. This is also expected. The voltage on the SW node in this condition should be kept below the abs max of 7V to avoid damaging the synchronous FET.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.