Greetings.
A little question about using TPS65070 wLED boost block. I don`t need it in my project, so i want to turn it off. So the question is how to do it properly. Can i just left it`s legs not connected or i must connect them to ground?
Best regards,
Vladimir
If the TPS65073 wLED (white light led driver) boost is not used, connect
ISET1 with a 100kohm resistor to ground
ISET2 with a 100kohm resistor to ground
ISINK1 to ground
ISINK2 to ground
FB to ground
L4 to ground