• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 63 subscribers
  • Views 809 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS65217: AC detect and USB detect

kura
Genius 4680 points
Part Number: TPS65217

There are AC detect and USB detect in P26 Figure 10. Block Diagram of the Power Path and Battery Charger.

Where these "AC detect" and "USB detect" are connected to in this IC ?

Regards,

  • 0
    TI__Genius 10000 points
    Hi,

    Thanks for using E2E. This thread has been assigned to an engineer familiar with this device. He will get back to you shortly.

    Best,
    Nastasha
  • 0
    TI__Mastermind 30260 points
    kura,

    Again, this circuitry shown in the block diagram could get complex quickly.

    The best way to visualize this connection is an op-amp comparator: the positive terminal is connected to the AC/USB rail and the negative terminal is connected to VIN(DT)/VIN(NDT), which are specified on page 7 of the datasheet for rising/falling edges of VAC or VUSB, respectively.

    The output of this comparator is wired to the digital block.

    Since the Battery (VBAT) is the primary supply to the system, VIN(DT)/VIN(NDT) are dependent on whether VBAT > VUVLO or VBAT<VUVLO.


    I hope this information helps with your design!