TI E2E Community
TPS659xx PMU Forum
TPS65950 Main Charger AC detection
I have connected a 5V DC power supply and a battery. I have ADCIN1 connected to ground via a 10k resistor and ADCIN0 grounded. In the BOOT_BCI register I have CVENAC = 1 and BCIAUTOAC = 1.
My expectation was to see automatic charging but instead the system is being powered from the battery and the AC source is being ignored altogether, no charging. The BCIMFSTS3 register shows BATSTSMCHG = 1 and CHGSTSMAIN = 1 but I see that the main charger state is RDSLSTATEC = 00000 - 'No charging device' in the BCIMSTATEC register. Why are these two registers showing conflicting information? Is there something I am missing to enable automatic charging from DC?
Did you resolve this issue?
I have the same problem.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.