Welcome to the PMU Section of the TI E2E Support Community. Ask questions, share knowledge, explore ideas, and help solve problems with fellow engineers. To post a question, click on the forum tab then "New Post".
Original Question: Can anybody please share the Board file / Gerber for the TPS65708YZHR EVM?
Answer: Gerber files for the TPS65708EVM-587 can be downloaded in the EVM tool folder under the software section.
http://www.ti.com/tool/tps65708evm-587
In the datasheet of TPS65708YZHR it is given that PWM is input for LED, and mode pin when it is low it is for power save mode and when it is pulled high it will work in PWM mode. We are using TPS65708YZHR for our application, in the layout as it is difficult to make drill the center pins as PWM and Mode, if PWM is only for input to LED then can I put NC for that pin? And Mode Pin if I make it NC then I don’t know what value it will take. So can you please suggest me what is the importance of mode pin? And if I made Mode pin as NC what problem can occur ?