Is TPS2379EVM-106 designed to comply with Cisco UPOE PSE?
Since it is my customer ask for it.
Thanks and Regards
Excuse me I may not have my question described clearly...
Can I double chk again,
for comply with 60w over 4 pairs UPoE Cisco switch in hardware circuit ,
we need two TPS2379 chip + dcdc, or one TPS2379 chip + dcdc, and why?
The TPS2379EVM circuit as designed can support a 60W load using a single TPS2379. TPS2379 provides the converter ON/OFF signal (CDB). You would have to add the dc/dc to the TPS2379 circuit as well as the PHY and supporting software to handle the LLDP communication (and any UPoE required software) with the PSE (TPS2379 doesn't do that part).
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.