TI E2E Community
Power Interface - USB, POE, Hot Swap, eFuse, & ORing Controllers Forum
TPS23750 application question
My customer(Vout 12V/1A) use PMP1360 reference design in their project and may we check some question with you?
*. we connect BL pin in "REF" pin. but PMP1360 BL pin is connect to ground. is this will case any issue?
I am not clear datasheet page9 explain.
*.Due to cost down, we have change Optocoupler from TCMT1107 to PC817A(CTR 80 to 160). Is also ok?
Blanking suppresses current sense operation at the beginning of the primary MOSFET switch ON period. When the MOSFET is turned on, there is a Source current that is due to the charge of the gate-source capacitance, currents resulting from drain voltage swing, and currents that might be due to output rectifier turn-off recovery (or other active devices in the circuit). Often this is referred to as a turn-on current spike. Oftentimes this spike magnitude can be larger than the programmed peak current limit or controled peak current (as in current-mode control), causing a false turnoff of the MOSFET.
Blanking is then one simple way of avoiding this problem. The downside to this is that the MOSFET current is uncontrolled (no protection) during this interval. Choice of the blanking interval is a tradeoff between clean operation (no false current limit switching) and device failure under shorted conditions of the output, or various devices around the MOSFET.
In your case, you have made the period longer. Be convinced that susceptability to failures is within your tolerance. Direct measurement of the "spike" is recommended. Bear in mind that false triggers are often their worst at light load in current-mode control.
PC817A (Sharp) looks like a suitable substitution. As always, you should test the change to validate it through phase-gain or (second choice) transient response.
Many thanks for you reply,
we met some issue that we test our board(reference PMP1360 Vout :12V/1A). when we power source to use adapter in. then output voltage start up is normal.
But when we power source use PSE, then output start up sometime normal. but sometimes output will steady 4.5V a few seconds then reach to normal 12V.
May you pls have some suggestion to us for debug?
The PoE input source is current limited. See the datasheet section "Converter Startup."
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.