TI E2E Community
NexFET™ Power MOSFETs
NexFET™ Power MOSFETs Forum
lm5102 problem top mosfet out (HO) is not swtiching
I am using LM5102. 50Khz signal is given as input for tOP mosfet and inverted 50khz signal is given as input for botom mosfet.
In the above circuit pin 4(HS) should connect to junction where top mosfet source and bottom mosfet drain connect. It is missed here but connected in hardware with a jumper. But the pin out HO (pin no 3) is not switching according to the input and at the same time there is switching at bottom output LO(pin no 10). Kindly helpme out whats wrong going on in the above circuit.
The circuit looks fine except that HS should be connected to F_Out as you have noticed. I would suggest you check the voltage across HB and HS to make sure there is sufficient bias for the high-side driver. Also check the HS voltage with reference to AGND. Bootstrap capacitor is charged when the HS is pulled low.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.