In my application, the ground pins of UCC27322-Q1 are connected
to a negative DC offset; the reason why I do this is I need the positive to negative
output swing voltage.
My question is how should I connect the power PAD, should I
connect the power PAD to negative DC offset or to ground?
If I connect the power PAD to negative DC offset, should I make a plane for this power PAD?
Sincere thanks for your answer.
even on people want to see a single word, so sad
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.