TI E2E Community
Power Modules - Forum
What importance has the correct value of capcitance have on the input of the PT6642?
It recommends a 330uF, but I have seen lower values used.
I am investigating why the input of the PT goes short.
If you dont use the remote sense as a true remote sense, ie at the load,
can you tie it local ground instead?
I am aware that the product is on the NRDR list.
Is there a time frame for end of supply?
PT6642x is on the NRND list. There is no time frame for its continued availability.
1. The remote sense can be either open or connected to ground
2. The required input capacitance is 560uF. Any less capacitance affect operation and its long term reliability. The schematic is attached.
3. PT6642 does not have over-current protection or over temperature protection..Any excessive output current or high temperatures which exceed the published thermal limits(SOA data) can overstress the module.
The thermal data is below.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.