I experienced mis-alignment issue with this particular component after SMT process and it was indicted by 5DX. What are the best set up and techniques to rework this part using hot-air gun as far as temperature setting of the heat gun, actual temperatur output, and distance?
We are facing some field failures due to this component and unsure if it caused by reworking.
Please share your idea.
complete. Contacted customer directly . SMT odules once removed are not recommended for resoldering .
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.