This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: DCP020515D
Hi, I'm using DCP020515D power module to get +-15V from USB +5V.
My schematics consists of only 4 elements and as I understand from the datasheet it should be enough.
On the input I use 2.2µF ceramic X8L capacitor between +Vs (USB 5V) and -Vs (USB GND)
On the output I use 1µF ceramic X7R capacitor between COM and +Vout and also another 1µF X7R cap between COM and -Vout
Measuring voltages with multimeter shows 28.40V between COM and +Vout and shows -25.7V between COM and -Vout
These voltages seems wrong because DCP020515D datasheet tells that max should be ±15.75V. So am I connecting something wrong or the measurement itself is not correct? Could you help me on this?
DCP020515D is a dual isolated power converter. The output voltage is dependent upon output loads . Each specified output voltage load range at 75% load / 50mA load ±14.25 ±15 ±15.75 with 5Vin at +/-1%.
Unload +/-Vout DCP020515 output voltage with no output loads can be as high as 25-30V on each polarity.
Attached is one method to limit +/- Vout to about 16 V with a 16V zener clamp and series resistor. Tom
DCPfilteroutput clamp16Vdual 2015.pdf
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Tom Guerin:
Hi, thanks for the response! What about if instead of zener diodes I used LDOs (TPS7A47 for 15V and TPS7A33 for -15V)? What would be cons and pros for this approach comparing to zeners?
In reply to Michael Prairie:
Is there anything else on your board that can be loading these outputs?
Can you send me the schematic? You can send it directly to me at firstname.lastname@example.org .
In reply to J Arrigo:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.