Tool/software: WEBENCH® Design Tools
When webench is initiated from the LMZ34002 product page (even with default parameters), there is an error as "no parts meet the requirements"
When the device is designed via the visualizer, the design completes successfully given the same inputs.
Please verify and make sure that the LMZ34002 can be launched successfully from the product page.
Hi Steve,
I've attached screen image of what I'm seeing when I click the "Open Design" in the quick launch panel for the LMZ34002. Can you check one more time to see if this is the case for you? I was recently informed yesterday night that this had been fixed and tested it this morning to get the following results below.
Regards,
Jimmy
