Hi team,I have one question regarding VEN_HYS torelance.I'd like to know min value and max value. Regards,K.Inagaki
I asked another engineer to see if they have the information. They were going to get back to me later this week.
Values for the LM3150 from one lot.
EN Rising Threshold
EN Falling Threshold (The rising threshold minus the falling threshold sets the hysteresis)
You can see that the max of the falling threshold is 79mV below the min of the rising threshold. This isn't to say that this is the minimum on the hysteresis because those two numbers were not measured on the same part.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.