TI E2E Community
UCD9090, (1) supports MON-1 to MON-11 but “Fusion Digital Power Designer GUI” only supports 10 inputs. (2) pin out do not match of data sheets page 23 & 6
1.) “Fusion Digital Power Designer GUI” interface does not allow an 11th pin to be added ( only 10 pins can be monitored). The chip itself supports 11 inputs. Customer wants ability to monitor all 11 inputs MON-1 to MON-11.
2.) Page 23 of data sheet, Table 4 " GPIO pin configuration Options" does not match pin assignment on page 6 "Device information".
1. For UCD9090, you can only define 10 voltage rails or 10 monitors used for voltage. The 11th can be used along with one of the 10 voltage rails as a temperature or current monitor (with appropriate scaling).
2. You are correct and thanks for the catch. It seems that all GPIO pin #'s in Table 4 are +1 from the correct value. I will submit this for correction.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.