We're using two UCD9081 devices on a single power management board for sequencing and monitoring different supplies. Let us know how to program both these devices using a single communication. Our GUI is able to talk to only one of these devices at a time. If both are connected, the communication fails
Thanks and regards,
Would you explain your setup in more detail? I can make some assumptions about it, but would rather understand it fully. Both from a hardware implementation perspective and your use of the GUI.
From what I recall, the GUI only has the capability of configuring parameters for 1 UCD9081 at a time. But you should be able to switch between which device you talk to based on the unique I2C device address. I assume the two UCD9081s have a unique I2C device address setup via resistor strap options.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.