This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCD90160A: Enabled GPIO's & FPWM's during power down

Part Number: UCD90160A
Other Parts Discussed in Thread: UCD90160

When the V33A & V33D supplies are powering down and between 3V and Vreset what happens to GPIO and FPWM Rail Enables that are in their enabled state during the power down?

Also, when V33A & V33D are powering down and below Vreset(2.4V max) will GPIO’s & FPWM’s go to their reset state, i.e. GPIO’s=Hi-Z, and FPWM’s driven Low?

BTW, I did see the E2E thread Re: UCD90160: Power Down and Fault Handling Guide, but it didn’t seem to address these specific questions.