Hi,
We bought an evaluation kit for the BQ500110EVM, and we are trying to find the gerber files without succes. The link that we were used to refer to these files was the following:
http://www.ti.com/tool/bq500110evm-688
this web page does not work anymore. Could we please have the link to get the gerber files and all related data.
Thanks
The bq500110 has been replaced by the bq500210 device.
EVM for bq500110 has been removed from the web and stock.
I can send you gerber files but if you are looking at a design you should switch to bq5000210.
Bill
Best Regards,
Bill Johns, Applications Engineer
bqTESLA Wireless Power Products
Texas Instruments Inc
Dallas, Texas
We definitively need the gerber files for the bq500110 since we will start a production based on the 500110 chip. It is important for us to keep all the data related to the refrence design.
We would appreciate that you provide us with the files required.
Thanks for your support
2045.HPA688A_Gerbers.zip
Gerber files for bq500110EVM-688A attached.
Hi Bill,
My name is Roger and i work with Robert on the same project and on the gerber files for bq500110EVM-688A you sent to him they miss some files. The paste file (for stensil), the X and Y file and PCB database in ASCII format. Can you help us for that?
Thank you for your help.
Roger Hebert
Hi Roger
The design files for bq500110EVM-688 are in PADS. Attached are the ASCII version of the schematic and layout, it may be possible to import them.
5807.HPA689A-Design Files-ASC.zip
I have attached additional files.
We do not generate the stensile, this is done by our CM.
8468.HPA689A additional fab - assembly files.zip
All
The folders for bqTESLA kits have been turned back on, see:
www.ti.com/tool/bqtesla100lp
www.ti.com/tool/bqtesla150lp
Also a folder for the bq500110EVM-688 has been set up, see:
www.ti.com/tool/bq500110evm-688
Gerber files are in this folder.
But the bq500110 is not recommended for new design it is replace by bq500210.