I use BQ51013 for Receiver Solution.In my project ,I will use air core coil without shield.
when I put coil on the Transmitter panel,it will be find after 15 sec.
How to solve?
The transmitter detects a receiver using an analog pin, which is a very short pulse of the transmitter coil about every 400mS. A receiver coil will load the analog ping and reduction in amplitude will be detected by the transmitter. It will then send a digital ping which is long pulse (10mS) at 175kHz, this will power the receiver and allow it to start the identification, configuration and power transfer phase.
But digital pin is sent automatically every 15 sec by the transmitter. This must be what is powering up your receiver.
It appears the coil is not placing a large enough load on the transmitter to be detected by the analog ping.
Send me coil details though the conversation option of the forum.
Bill Johns, Applications Engineer
bqTESLA Wireless Power Products
Texas Instruments Inc
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.