TI E2E Community
RF & Digital Radio
Digital Radio (GC Products)
Digital Radio (GC Products) Forum
GC5316 ddc use only
If i use ddc only, can i leave txclk unconnected?
It is not a good practice to leave pins unconnected, as there is an ESD structure for each pin. They should be connected to GND, or through a series resistor to 3.3v IO power.
I suggest connecting unused pins (not RESETB - this must be connected to Power-OK), to GND.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.