TI E2E Community
RF & Digital Radio
Digital Radio (GC Products)
Digital Radio (GC Products) Forum
gc5316 power up
Is there any requirements to power up sequence of the chip?
First 3.3V, then 1.5V, or doesn't matter?
The GC5316 has a 1.5v core, and 3.3vIO power . The RESET_N signal should be held low on startup until the
1.5v core and 3.3v IO are within tolerance. As long as the RESET_N is low, the power supply sequece is not required.
Both power supplies should be applied within 100ms. Some hardware design to avoid MPU 3.3v bus contention, such as a pull up resistor
for Chip_enable_N should also be used.
Just to be sure: Is RESET_N a full hardware reset?
I mean this case:
If RESET_N not tied low _while_ on startup, will i get the same result if i assert RESET_N low some time _after_ startup?
I want to use FPGA to interface GC, but i think FPGA will not be already loaded while GC IO and core voltages are starting up...
Or i should use some pulldown on RESET_N line?
A pull down resistor for the TRST and RESETN should be applied if the FPGA is not available to pull this low during startup. The FPGA can output a '1' to these
signals after the power supplies are OK. The part is only tested with RESETN TRST low to high when the power supplies are off and then valid.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.