Hi,
i'm using the CC430F6137 for a datalogger project and want to tranfser data from one module to another via RF.
The transmitter Modul is a EM430F6137-900 development board and the reciever Modul is the self designed datalogger board.
I strictly hold on the given Design in SLAU278 known as the Typical Application Circuit CC430F61xx but i dont get a connection.
The connection has been tested in SmartRF Studio 7 as shown in the screenshot beneath.
As you can see the RxModule does not get any Signal from TxModule even when i try different frequency's (TxModule was working while i took this image)
With two EM430F6137-900 boards there there is no problem so it finally has to be a problem on my datalogger board
Does anybody has an idea what the problem could be?
I try it since 3 day's and have no idea because the RF Part on the design is completely copied out of the applicationnotes
i'm happy for any suggestion
thank u
mike
HI Mike..
Did you find solution to your problem.. I am facing a similar problem.
Thank You
Vivek
...V