Problems GD0x CC1101

IraisCO Galvez

Other Parts Discussed in Thread: CC1101

Hi, I'm working with a CC1101 module whit a PIC32, the problem is that despite I continuously set rx mode,if for a while it have not received anything, it is unable to activate the interruption by the pin GDOx.

PLEASE HELP ME

over 9 years ago

0 TER over 9 years ago

TI__Guru**** 317180 points

Please elaborate.

- What is your register settings

- What is your code

- Have you checked with a scope if you get a signal on GDO0 (is it an issue with the PIC or the radio)

0 IraisCO Galvez over 9 years ago in reply to TER

Prodigy 30 points

Hi, I've been doing tests and the problem apparently is that CC1101 enter in the RXFIFO_OVERFLOW state and it is impossible to return to RXstate,
How can I put CC1101 in rx again?

0 TER over 9 years ago in reply to IraisCO Galvez

TI__Guru**** 317180 points

See figure 25 in the Datasheet.

Also read the sticky post first in this forum where to post questions.

0 IraisCO Galvez over 9 years ago in reply to TER

Prodigy 30 points

Thanks

/etc... RF (Read-Only)

/etc... RF (Read-Only) Forum

Problems GD0x CC1101