we consider switching on/off supply for TRF3711. What will be an influence of switched supply on the thermal drift of parameters? And what will is the minimal transition time from state off to state on after swithcing on supply?
If you are considering switching off the power supply to save power then I would suggest to utilize the Chip Enable pin to toggle the device off instead of switching off the entire powre supply. The device will come back to a good state and stable within a few microsecond if using the chip enable. I do not have any data for the transition times when switching on/off the entire power supply to the chip but it will be longer than with the chip enable.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.