TI E2E Community
RF & Digital Radio
High Performance RF Modulators, PLL and VCO products
High Performance RF Modulators, PLL and VCO products Forum
LM2531 failure to detect lock
We're using an LMX2531LQ1742 to synthesize 904MHz. The reference input frequency (OSCin) is 49.156MHz. According to the LM2531 datasheet (see paragraph 2.7.8), XTLSEL should be set to 1. But when writing 1 to XTLSEL, the Lock Detect output (Ftest/LD) is low and intermittently high, even though the VCO is locked. When writing a 2 or 3 to XTLSEL, the Ftest/LD pin is a solid and steady high, and the VCO stays locked.
What is the recommended setting? Why does the status bit toggle when set per the data sheet? Thanks and Best Regards,
-Tim Starr on behalf of HD@CS
What I think is happening is that the calibration is finding a VCO band that works, but is not as optimally centered as it could be. Perhaps you are using a higher phase detector frequency and modulator order, which makes it harder for the digital lock detect. I would recommend using the manual mode for a more optimal calibration that better centers the charge pump voltage as follows:
XTLMAN2 = 1
XTLDIV = 3
XTLMAN = 16*49.152/2.5 = 315
XTLSEL = 4
In addition to this, if you are running a higher order modulator or higher phase detector frequency, this makes it harder for the digital lock detect. For diagnostic purposes, you might try reducing the modulator order to see the impact. Also, for this device, if you are not using the highest charge pump gain, consider increasing this and decreasing the phase detector freuquency. The higher charge pump gain has a large impact on the phase noise. The National Clock Design Tool at http://www.national.com/en/clock_timing/codeloader.html simulates phase noise and fractional spurs.
Hello, President! I use LM2531LQ1910 chips. Output frequency is 942MHz. OSCIN input frequency: 26MHz. VCO can be locked, but the lock detect output (Ftest / LD) is always low. I ask whether it is configured wrong, my all registers are configured as follows:
R0:0x216300 R1:0x2E6A41 R2:0x5D4042 R3:0xCDF193 R4:0x3C0004 R5_1:0x840005 R5_2:0x800005 R5_3:0x8007F5 R6:0x6 R7:0x7 R8:0x28008 R9:0xBA9 R10:0 R11:0 R12:0x1048C
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.