This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

FDC1004: enabling standby mode

Part Number: FDC1004

Hey

I am using the fdc1004 for a low power water level monitoring solution. I wish to keep

the device in standby mode, take measurements and then go back to standby mode.

How can I achieve this? I didn't find any reference to standby and power saving modes

in the data sheet not any register value settings to enable this. 

Please help thanks.

  • Hi Karan,

    The FDC1004 automatically enters standby mode when it is not completing measurements. The device is only in active mode after receiving a measurement trigger. The length of time it spends in active mode depends on the value in the REPEAT register and the measurement rate.

    Regards,