Starterware/HDC1080EVM: integrating HD1080 into my test setup

Onur TANYERI

Prodigy 20 points

Part Number: HDC1080EVM

Tool/software: Starterware

Hello

I would like to use the HD1080 for a test setup that I have

I need to read temperature and humidity information from multiple dongles.

I think the EVM GUI does not let you do that is there an interface I could use to communicate with multiple EVM boards over a PC

thank you for your help in advance

regards

over 6 years ago

0 Ben Kasemsadeh over 6 years ago

TI__Genius 13650 points

Hello Onur, we do not currently have a GUI for this device that allows connection of multiple EVMs on one PC. I apologize about the inconvenience.

0 Onur TANYERI over 6 years ago in reply to Ben Kasemsadeh

Prodigy 20 points

Hello,

You not having a problem is not an issue thank you for the reply.
Could you pass me the command set used in your GUI to extract temperature adn humidity of the EVM so that I can
prepare my own software to be able to use it in my system?

regards

0 Ben Kasemsadeh over 6 years ago in reply to Onur TANYERI

TI__Genius 13650 points

Hello Onur,
the source code for our HDC firmware is automatically installed into the following folder after installing the sensing solutions GUI: C:\ti\Sensing Solutions EVM GUI-1.9.2\EVM Firmware\Older Revs\HDC10x0_EVM_Firmware_source

Will this help?

Sensors

Sensors forum

Starterware/HDC1080EVM: integrating HD1080 into my test setup