Part Number: LDC1312-Q1
Is it ok to make a 4 layer board, with two layers of coil, one layer for ground and one layer for LDC1312 and other components. I want to keep size of the board not more than the size of coil. Is this approach ok? Or do I have to make two separate 2 layer boards and connect the PCB inductor from one board to another using connectors?
Analog Application Engineer,
Texas Instruments (India) Pvt. Ltd.
In reply to Luke LaPointe:
Customer not yet made the layout. He want to understand whether it can be done this way. Two layers of coil facing towards target and rest two layers of traces and components.
In reply to Naveen Bevara:
It sounds like the customer wants to do something like:
This design has many limitations and is far from optimal. The ground plane under the sensor will greatly reduce the Rp and sensitivity. These issues are most pronounced with small sensors (<15mm diameter). It is better to design a PCB where the sensor is physically offset from LDC and ground plane:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.