• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 31 subscribers
  • Views 569 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

About accident of LDC1314

Satoshi
Guru 19485 points
Other Parts Discussed in Thread: LDC1314

Please let me know about two point below of LDC1314

・When magnet or speaker coil close to a sensor coil, is there a problem?

・Please let me know the movement when being Overload. 　

  For example, threshold in Overload, movement at overload(Latch or Retly).

  ※LDC1000 was OSC Dead, but LDC1314 wasn't found.

 

Best regards,

Satoshi

  • 0
    TI__Genius 14270 points
    Hello Satoshi-san,

    If you place a magnet near the LDC1314 sensor, the response of the LDC depends on how conductive the magnet is. Many magnets are coated in a conductive metal covering, the LDC will detect the covering.

    Some soft ferrite magnets will be detected as an overall increase in the inductance of the sensor.

    As for a speaker coil, the response to the speaker coil will be based on the conductive characteristics of the speaker coil.

    Please clarify your question on the Overload movement.

    Regards,

    ChrisO
  • 0 in reply to Chris Oberhauser66
    Guru 19485 points
    Dear Chris Oberhauser-san

    Thank you for reply.

    About speaker coil, I think that speaker coil depend on frequency characteristics.
    When different in a frequency of LDC1314 and Speaker coil, it's no problem.
    Is it correct?

    best regards,
    Satoshi