IWR1443BOOST: How do i load a config file into my IWR1443 device

neha gandhi

Part Number: IWR1443BOOST
Other Parts Discussed in Thread: IWR1443

Hi,

I am trying to make my own config file using the parameters obtained from mmWave Estimator tool and load into the IWR1443 board. But i cannot find anything in the mmWave demo Visualizer that supports this feature. Can somebody please tell me how this can be done?

Regards,

Neha

over 6 years ago

0 Akash Gondalia over 6 years ago

TI__Guru 50240 points

Hi Neha,

There is no way to directly export the parameters to a chirp configuration, however there is another method for retrieving some parameters in the correct format.

If you save a config file in the estimator and then press F12 you will be able to see the developers pane on your web browser. If you look in the Console window you will see the parameters for ProfileCfg and FrameCfg in the correct format that are ready to be copied and pasted into an existing chirp configuration.

I would say that this is the best method for this that is currently available.

Cheers,
Akash

0 BhavinKharadi over 6 years ago in reply to Akash Gondalia

TI__Genius 9020 points

0 BhavinKharadi over 6 years ago in reply to BhavinKharadi

TI__Genius 9020 points

Above picture has it highlighted in RED colored block.

Regards,
Bhavin

Sensors

Sensors forum

IWR1443BOOST: How do i load a config file into my IWR1443 device