Other Parts Discussed in Thread: UNIFLASH
Hi guys.
In order to try some examples(ground water classification, vital labs...), I have to flash using the uniflash program.
But I got this kind of an error message.
To solve this problem, I already googled it and found this thread(e2e.ti.com/.../2771525).
In this thread, someone said to check these kinds of things.
Here are a few items to look at:
1. Please confirm that the board was power cycled after jumpers SOP0 and SOP2 were installed.
2. Please confirm that the power supply can supply at least 2.5 Amps at 5V.
3. Please close any other programs that can control the COM port (TeraTerm, Matlab, etc.)
4. Please try the latest version of Uniflash (currently 4.5.0.2056). You can also try the cloud version to see if it makes a difference.
I confirmed all of 4 things were satisfied.
But I still get the same error message.
You can see some of my configurations from the following pictures.
What else can I try to solve this problem?
