CCS/PGA900: How to down load firmware to PGA900 OTP by XDS200?

hao Su

Intellectual 520 points

Part Number: PGA900
Other Parts Discussed in Thread: UNIFLASH

Tool/software: Code Composer Studio

Hi:

I have build firmware and can debug well by XDS200. But I don't know how to down load firmware to PGA900 OTP by XDS200?

PGA900 EVM still can't work after I remove XDS200 and reset the board.

over 5 years ago

0 Scott Cummins over 5 years ago

TI__Mastermind 31655 points

Hello,

Is this intended just for debug purposes or for programming PGA900 devices in a production environment?

For a production environment we suggest using the Uniflash tool: www.ti.com/.../UNIFLASH

For debug purposes (which is limited of course, since the OTP can only be flashed once) you can change the memory space from the DEVRAM to the OTP space in CCS, but it will require altering some setting files.

I suggest trying Uniflash for now.

Regards,

0 hao Su over 5 years ago in reply to Scott Cummins

Intellectual 520 points

Hello:
How to change firmware to make firmware be loaded in DEVRAM or OTP?
I can't find detail description in firmware guide.
thanks

0 Scott Cummins over 5 years ago in reply to hao Su

TI__Mastermind 31655 points

Hi Hao,

It was not intended for the OTP to be programmed through CCS, so it is not described in the available documentation. I suggest using Uniflash if you would like to load the OTP using the XDS200 tool.

Regards,

Sensors

Sensors forum

CCS/PGA900: How to down load firmware to PGA900 OTP by XDS200?