CCS/PGA411-Q1: PGA411-Q1

Hi Clancy.

Thanks for the reply.

I already tried it out but in that case I haven't got any data from pga411, not even default value.

I checked the status registers and fault pin to see if any fault is present but there is no fault.

Chintan,

What do you mean that you don't get any data from PGA411 in that case? Have you verified that you are reading back the data properly? If you read back DEV_PHASE_CFG, does it reflect the programmed value?

Hello Clancy,
First of all thanks for the reply.
That was my mistake, I am getting the data.
I am reading back the data properly but it is default value, not the programmed value.

Chintan,

Even without programming the EEPROM, you should be able to see the register changes after you do register write operations. I recommend debugging that issue first before worrying about the EEPROM.

Are you in diagnostics state before you do the write operation? Every register except for DEV_CONTROL3 (which is how you enter and exit diagnostics and normal states) can only be written to while in diagnostics state.