This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: AWR1843
A common question regarding uniflash is how not to erase entire flash when flashing new binaries.
For example, a common use case is to store calibration coefficients in Flash. So, let's assume that we flash the calibration coefficients and then, after that, we have an updated version of the sw that needs to be flashed.
When using Uniflash with default configuration, the entire flash will be erased (formatted) and the calibration. In order not to erase the entire flash the following configuration must be modified.
Disable in “Settings&Utilities” the Format Check Box (see below)
When this checkbox is disabled the complete flash will not be erased
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.