This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello! Help me to find a modern replacement for the 74HC4066 chip.
Options: 4 independent key, the voltage of +5V, the switching frequency is not lower than 30 MHz. The resistance of the keys 4-10 Ohms, or less.
And the most important thing! To the keys inside was controlled antiphase to the control signals into the conclusions of the keys as little as possible!
See in figure? The penetration rate of the control signal on the findings of the key - picovolt
look, what i need.
1. When there is no modulation, the penetration rate of the control signal (carrier) 3.1 mV rms, it gives the suppressed carrier relative to the modulation level of about -28dB.
2. It gives the suppressed carrier relative to the modulation level of about -28dB. It is very small!
So, iI need a chip, in which the penetration level of the control signal on the findings of the keys will be about 0.1 mV rms, or even less. This will provide suppression of the carrier signal relative to the modulation is about 50-60dB.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Victor Orlov:
The MC74HC4066 and ADG712 are both 4-channel 1:1 switches. These are the search results from the TI.com switch selection tool for 4-channel, 1:1 switch, with 5V supply voltage and <10 ohms on state resistance.
Please let me know if these switches are what you are looking for.
In reply to Adam Torma:
I haven't found the right chip. Again, please view these pictures, that's what I need. Need the chip, where the level of this voltage noise of the control signal will not be stronger than the 0.1-0.3 mV
All the chips I found had a noise level of 20-100mV, but I have no more than 0.1-0.3 mV!
Adam, here www.ti.com/.../cd74hct4066-q1.pdf:1230:0]
I didn't see that information in the CD74HCT4066 or CD74HCT4066 datasheet.
Another way the crosstalk from the digital control pin is specified as charge injection. TS12A44513 looks like a device above that has low charge injection.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.