This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: SN74CBTLV3125
I have one question about SN74CBTLV3125.
What is the minimum voltage of VIL? Does it mean if voltage is <0.8V, the output is ensured LOW?
Only maximum value is marked in datasheet.
The minimum voltage allowed on the OE pin is 0 V.
If the voltage on the control logic OE pin is <0.8V it will be recognized by the device as receiving a logic low signal. The device will respond based on the truth table and turn on the A to B path.
The opposite is true for the Vih. When the voltage on the OE pin is > 2 V the device will receive a logic high signal and respond based on the truth table turning off the A to B path making it Hi-Z.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Adam Torma:
Thanks for reply.
How about the risk if A port minimum voltage is -0.3V? Will it influence the logic output at B port?
Adam, What is the minimum voltage allowed on A and B path?
I notice it rail-to-rail switching on Data I/O ports,so does it mean the Vi range allowed on A and B path is same as the Vcc which is -0.5~4.6V ?
I got a signal which the minimum voltage is -0.4V through the path B,is there any risk on it?
In reply to Johnny Guo:
The SN74CBTLV3125 device doesn't have any drive capability it simply passes a voltage from one side of the switch to the other so the B port could be the input or output depending on where the source and the load is in the system.
I understand the confusion when looking at the older datasheets that doesn't have a recommended operating conditions table but -0.3 V is outside the recommended operating conditions. The recommended operating conditions for this device on the A and B signal path is 0 to Vcc.
There are ESD protection diodes on the A and B I/O path to Vcc and GND. As the voltage on the I/O pins exceed 0 to Vcc the ESD diode will begin to conduct and cause leakage through the diode.
user5774538 does this help with your question as well?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.