This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TS3A227E
Please help me review TS3A227E schematic, especially MICP and MIC_PRESENT#,
As below information for your reference, thank you.
SCHEMATIC1 _ 0x_AUDIO CODEC_20180410A.pdf
Power pins: VDD is supplied with 3.3 V and is within the recommended operating conditions.
GND is correctly connected to the thermal pad and the unused GND sense line may also be connected to ground.
I2C SDA/SCL open drain outputs are pulled up to 3.3 V and are within the recommended operating conditions.
INT is an open drain interrupt and I couldn't find where it was going
MIC Present is also and open drain interrupt and it correctly attaches to a GPIO
DET Trigger is correctly connected to a switch in the combo audio jack that will pull the node to ground when a headset is inserted into the Jack
Tip/Ring2/Sleeve correctly connected to the audio jack
Sleeve Sense and Ring2 sense correctly connected to audio jack
MIP correctly connected to the codec.
Also please be aware of this post as well for Apple headsets.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Adam Torma:
In reply to Sam Liu69:
Thank you for your reply,
about MIC_PRESENT#, I will connect to "Sense A" pin of codec,
about INT#, I still confirm whether we need this pin,
ALC262 don't have "ground sense pin", so I couldn't connect to "GND_SENSE" of TS3A227E,
last, about C3(in the schematic is C111) that value can vary depending on codec needs,
could I change to 1K ohm?
SCHEMATIC1 _ 0x_AUDIO CODEC_20180412A.pdf
I only want to confirm C3 not R6, as below is request from codec vendor,
should I added C3(1uF) into below portion? thank you.
The TS3A227E does not require the C3 cap but was included in the datasheet to show in a typical application the codec will require a DC blocking cap. Please refer to the recommendation of the codec vendor for the capacitor you will not need an additional one for the TS3A227E.
As below is from recommendation of the codec vendor that don't use the capacitor(C3),
only added 1K, so if no C3, is it ok? thank you.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.