CCS/TIDA-00961: Frequency Response for Build 2 and Build 3

Wayne Grandner

Part Number: TIDA-00961

Tool/software: Code Composer Studio

I am having problems getting the Frequency Response sweep from the prototype board. I followed the instructions in the Software Guide

See attached. Is this sweep correct?

This is sweep for Build 2

This is sweep for Build 3

0 Ryan Tan over 4 years ago

Hi,

Thank you for your interest on TIDA-00961. Our designer is taking AL today and will give detail comments tomorrow.

Best Regards,

Ryan

0 Desheng, Guo over 4 years ago

obviously. it is not correct. but, I don't know what happened.

0 Wayne Grandner over 4 years ago in reply to Desheng, Guo

Can you supply a copy of what the Frequency sweeps should look like?

How is the frequency sweep implemented

0 Desheng, Guo over 4 years ago in reply to Wayne Grandner

hi,

hope your problem is solved.

Please refer to the TIDA-00961 software design guide in the Fig13 and Fig 14.

Simulation, hardware & system design tools forum