TI E2E Community
Low Power RF Tools Forum
CC2500 frequency synthesizer calibration
The datasheet of cc2500 mentions that the 'frequency synthesizer must be calibrated regularly'.It does not mention how often. The chip can be set for auto calibration on entering/leaving RX/TX modes from IDLE states. If i need to put chip in TX mode always this autocalibration will not occur. I do not want to set the chip to IDLE state after each packet which would require me to enter TX state every time i want to transmit some data.
I need to know how often this need to be calibrated if i want only TX and want to leave it in TX mode.
Also I would like to know why this need to be calibrated often even though there is a PLL and an external crystal.
or am i missing something here ? I don't need to change channels while operating
I am also wondering the same thing. Anyone have any answers?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.