[CC2650STK] [XDS110] Do I need to modify sensortag FW to use the grove ports ?

guillaume Connanec

Hello,

I am discovering the sensortag and I would like to know if I need to modify the sensortag FW to get the values of sensors connected to the grove ports.

I need to add a sensor on grove 1 or 2 (I have an analog output on my sensor).

Best regards,

Guillaume

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735455 points

Yes, you have to modify FW to get the values of sensors connected to the grove ports. However, TI doesn't release related source code example so there is no reference example.

0 guillaume Connanec over 8 years ago in reply to YiKai Chen

Prodigy 105 points

Thanks for the reply.

Do you think we could have an example of how to use these grove ports in the futur ?

I'm not an expert and it seems to be quite hard to do without it.

0 YiKai Chen over 8 years ago in reply to guillaume Connanec

Guru 735455 points

Yes, I think TI would release example and source code for the grove ports in the future.

0 guillaume Connanec over 8 years ago in reply to YiKai Chen

Prodigy 105 points

There is a wiki on how to use the LCD devpack and the LED/Audio devpack.
It was uploaded one or two weeks ago.
processors.wiki.ti.com/.../CC26xx_LCD

The next step is a wiki on how to use Debug Devpack ?

I would like to know when source code examples will be available.

Best regards,

Guillaume

0 YiKai Chen over 8 years ago in reply to guillaume Connanec

Guru 735455 points

Here is the wiki show how to use CC-DEVPACK-DEBUGGER. What do you mean when source code examples will be available?

Bluetooth®︎

Bluetooth forum

[CC2650STK] [XDS110] Do I need to modify sensortag FW to use the grove ports ?