CC1310 - Read MAC address

Ewen COCHENNEC

Hello,

I'm working on the Wake on radio example from TI RTOS and I would like to read the MAC address to send it into my packet.

How can I do it?

Best regards,

over 7 years ago

0 TER over 7 years ago

TI__Guru**** 317180 points

If you use Flash Programmer 2 you can read out the MAC address. In the tool you can also find the address you have to read to get the value.

0 Ewen COCHENNEC over 7 years ago in reply to TER

Prodigy 190 points

I don't use Flash Programmer 2. I'm modifying the Wake on radio example to make my own code and I need to read out the MAC address then transmit it. And I want to know if there is a method or a command to read it out from this example ?

0 Siri over 7 years ago in reply to Ewen COCHENNEC

TI__Guru* 79421 points

Please see

Siri

0 Ewen COCHENNEC over 7 years ago in reply to Siri

Prodigy 190 points

Thanks Siri !

I have another question, I'm trying to switch RX / TX mode.

So I am doing RF_open, RF_runCmd then RF_close when i want to switch. But it doesn't work, it is a bit better when I use RF_yield. But I can only make TX -> RX -> TX and RX -> TX -> RX when I try to switch again it doesn't work. I don't understand what it is happening.

0 TER over 7 years ago in reply to Ewen COCHENNEC

TI__Guru**** 317180 points

Please take a look at e2e.ti.com/.../1843518

Here you will find and example on how to switch between Tx and Rx

Sub-1 GHz

Sub-1 GHz forum

CC1310 - Read MAC address