CC2538: Sample Switch is not connecting with OTA CoOrdinator

Hi Chen,

My Sniffer is on Channel 11, and my devices too in Channel 11

Please find the Capture in attach

UbiquaCapture3.zip

Thank you

According to your sniffer log, there’s no coordinator on channel 11 and it’s 100% sure.

Hi Chen,

OTA  Coordinator is visible in Ubiqua Protocal analyser you can check out the capture

UbiquaCapture4.zip

Thank you

According to your sniffer log, the coordinator doesn't enable permit join.

I made erase and ree-boot again as you told again the same issue

UbiquaCapture5.zip

Thank you

Hi Chen,

Yes its showing and  but devices even After "Device Scan" or after"Leave PAN" I tried Leave PAN because document say's If device was connected before opening with OTA Server we can find after Leave PAN by its own Restarting.

Please find the attach

Thank you

Try to add the following red lines in OTA_Dongle_event_loop() and test again.

uint16 OTA_Dongle_event_loop( uint8 task_id, uint16 events )
{
  afIncomingMSGPacket_t *MSGpkt;

  (void)task_id;  // Intentionally unreferenced parameter

  if ( events & SYS_EVENT_MSG )
  {
    while ( (MSGpkt = (afIncomingMSGPacket_t *)osal_msg_receive( OTA_Dongle_TaskID )) )
    {
      switch ( MSGpkt->hdr.event )
      {
        case ZDO_CB_MSG:
          OTA_ProcessZDOMsgs( (zdoIncomingMsg_t *)MSGpkt );
          break;

        case MT_SYS_APP_MSG:
        case MT_SYS_APP_RSP_MSG:
          OTA_ProcSysAppMsg((mtSysAppMsg_t *)MSGpkt);
          break;

        case ZCL_INCOMING_MSG:
          // Incoming ZCL Foundation command/response messages
          OTA_Dongle_ProcessIncomingMsg( (zclIncomingMsg_t *)MSGpkt );
          break;

        case KEY_CHANGE:
          OTA_Dongle_HandleKeys( ((keyChange_t *)MSGpkt)->state, ((keyChange_t *)MSGpkt)->keys );
          break;

        case ZDO_STATE_CHANGE:
          OTA_Dongle_devState = (devStates_t)(MSGpkt->hdr.status);

          if ((OTA_Dongle_devState == DEV_END_DEVICE) || (OTA_Dongle_devState == DEV_ROUTER) || (OTA_Dongle_devState == DEV_ZB_COORD)){
            NLME_PermitJoiningRequest(0xFF);
            OTA_Send_JoinInd();
          }
          break;

Hi Chen,

OTA upgrade is not happening, after device connected I am clicked "Image Notify" and tried "Broadcast  Image Notify" also.

and in other hand "Version Check image file" is disabled.

Please look at the attach's

thank you

Cheers!