#/* --COPYRIGHT--,BSD_EX
# Copyright (c) 2013, Texas Instruments Incorporated
# All rights reserved.
#
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
#
##  Redistributions of source code must retain the above copyright
#    notice, this list of conditions and the following disclaimer.
#
##  Redistributions in binary form must reproduce the above copyright
#    notice, this list of conditions and the following disclaimer in the
#    documentation and/or other materials provided with the distribution.
#
##  Neither the name of Texas Instruments Incorporated nor the names of
#    its contributors may be used to endorse or promote products derived
#    from this software without specific prior written permission.
#
# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
# AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO,
# THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
# PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR
# CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
# EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO,
# PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS;
# OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
# WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR
# OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE,
# EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
#
#******************************************************************************
#  PCM512x,4x,5x Code Example: I2S Slave mode with 4wire PCM/I2S Interface (including Master Clock)
#
#  Description: The PCM51xx family in software mode (I2C or SPI) can auto configure all clocks and PLL's 
#	When it has SCK, BCK and LRCK.
#
#
# 	Connection
#
# 	SCK : input terminal (24.576MHz)
# 	BCK : input terminal  (64xFs)
# 	LRCK : input terminal (1xFs)
# 	DATA : input terminal
#
#
# 	Commands below are written in the TI-Tools for for I2C. (Codec Control, Purepath Console and Purepath Studio all support this format).
# 	Format: 
# 	A BBh CCh DDh
#
# 	A = R or W (read or write)
# 	BBh = I2C Address (98 in this case)
# 	CCh = Register
# 	DDh = for Writes, it's the data, for reads, it's the number of bytes to read back.
# 	Either # or # can be used for comments.
#
#  Dafydd Roche
#  Texas Instruments, Inc
#  August 2013
#******************************************************************************

#### Make sure that Auto Clock Config is enabled ####
w 98 25 00

#### Stand-by request and release ############
# Stand-by request
w 98 02 10
# Stand-by release
w 98 02 00
##############################################
