insmod sdhci-esdhc-imx.ko
[   29.873308] mmc0: no vqmmc regulator found
[   29.877458] mmc0: no vmmc regulator found
[   29.948447] mmc0: SDHCI controller on sdhci-esdhc-imx25.0 [sdhci-esdhc-imx25.0] using DMA
[   29.957007] mmc1: no vqmmc regulator found
[   29.959464] ### sdio reset -110
[   29.962774] ### mmc_go_idle 0
[   29.963227] ### mmc_send_if_cond 0
[   29.963237] ### enter mmc_attach_sdio
[   29.964971] ### mmc_send_io_op_cond -110 0 100
[   29.981484] mmc1: no vmmc regulator found
[   30.048904] mmc1: SDHCI controller on sdhci-esdhc-imx25.1 [sdhci-esdhc-imx25.1] using DMA
[   30.098766] mmc0: host does not support reading read-only switch. assuming write-enable.
[   30.111676] mmc0: new high speed SDHC card at address aaaa
[   30.119491] blk_limits_max_hw_sectors: set to minimum 8
[   30.128605] mmcblk0: mmc0:aaaa SL16G 14.8 GiB 
[   30.156562]  mmcblk0: p1
[   30.170914] ### sdio reset -110
[   30.180604] ### mmc_go_idle 0
[   30.196421] ### mmc_send_if_cond -110
[   30.200453] ### enter mmc_attach_sdio
[   30.206009] ### mmc_send_io_op_cond -110 0 100
[   30.249604] ### sdio reset -110
[   30.256127] ### mmc_go_idle 0
[   30.259729] ### mmc_send_if_cond -110
[   30.263426] ### enter mmc_attach_sdio
[   30.269547] ### mmc_send_io_op_cond -110 0 100
[   30.309996] ### sdio reset -110
[   30.316650] ### mmc_go_idle 0
[   30.320498] ### mmc_send_if_cond -110
[   30.324193] ### enter mmc_attach_sdio
[   30.331113] ### mmc_send_io_op_cond -110 0 100
[   30.381311] ### sdio reset -110
[   30.388409] ### mmc_go_idle 0
[   30.392922] ### mmc_send_if_cond -110
[   30.396620] ### enter mmc_attach_sdio
[   30.406179] ### mmc_send_io_op_cond -110 0 100